My new post.

Lateral Stability for Masonry in Nashville Structures

Masonry in Nashville, generally consisting of bricks or blocks laid in courses and interspersed with cementitious mortar, is in essence a composite ceramic material. Ceramic materials by their very nature are high in compressive strength, stiff, hard and low in electrical and thermal conductivity. These properties make them useful building materials, however ceramics are also very brittle, which means that they have a low tensile strength in comparison to other materials, such as steel.



Not only is Nashville Masonry Services weak in tension, but as a result of the traditional construction methods there are also areas of weakness within masonry structures. This is because the bricks or blocks are laid in courses and bedded in mortar. The mortar forms joints between the individual clay or concrete units of masonry, both horizontally and vertically, at which there are inherent structural weaknesses. It is at these points where wall panels, columns and piers are most likely to fail as a result of lateral loading. The weakest joints in a masonry wall panel are at the horizontal "bed joints", with enhanced strength perpendicular to the bed joints provided by the shear effects of "keying" (overlapping) of the masonry units at alternate layers.



For slabs or walls constructed from isotropic materials (that is to say materials whose properties do not deviate dependent upon orientation) and supported on four sides it is typical that the material will "span" the shortest distance. This means that the majority of the forces will be accommodated by the slab or wall in an orientation relative to the shortest distance between supports. Masonry wall panels are no different because they are isotropic in the sense of their stiffness, and, like a reinforced concrete floor slab, a vertical masonry wall panel also requires support (as a result of lateral load imparted upon it - which is generally by virtue of wind pressures). A wall panel constructed as part of a typical dwelling will therefore generally span vertically - between the ground and a supported floor or roof.



The disadvantage of the wall panels spanning vertically is that when subjected to lateral wind pressures the resultant bending of the panel subjects the bed joints to tensile forces - and as previously explained these are the weakest points in a masonry wall panel. Therefore, in order to reinforce the wall panels which otherwise would span vertically, it is necessary to install buttressing "shear" walls. This ensures that at least a proportion of the panel spans horizontally, and that the stress on the wall panel is carried by the shear effects occurring as a result of keying of the masonry units in the vertical direction. These buttressing supports can be provided by suitably designed masonry returns, or otherwise steel frame structures.



In the UK, the Building Regulations Approved Document A for structures outlines the limiting dimensions for a buttressing masonry wall or pier. BS5628 part 1, (the code of practice for the structural use of unreinforced masonry) specifies that no lateral load-resisting wall panel should have dimensions (defined by support positions) of greater than 50 times its effective thickness, which, for a cavity wall formed of two 100mm leaves of masonry is 6.65 m. The successor to BS5628, Eurocode 6, stipulates wall panel limiting dimensions relating to span distances and thicknesses, though it states that these dimensions are for the purpose of ensuring adequate serviceability (so that finishes do not deteriorate) rather than ultimate limits of allowable load before failure.



So why does ensuring that masonry walls are adequately supported against lateral loads matter? Well, there are two answers to that question - one is of serviceability and one is of ultimate structural capacity before failure.



Clearly we do not want our wall to fall down as a result of wind loading, so there is a clear incentive here to ensure that the wall panel is sufficiently strong that it will not collapse, but what about serviceability? What are we worried about? Surely if a wall doesn't fail then there is nothing to worry about?.. Well, it depends on your attitude towards construction.

This blog post is actually just a Google Doc! Create your own blog with Google Docs, in less than a minute.